1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
|
// SPDX-License-Identifier: GPL-2.0+
#include "px30-u-boot.dtsi"
/ {
config {
u-boot,mmc-env-offset = <0x5000>; /* @ 20KB */
u-boot,efi-partition-entries-offset = <0x200000>; /* 2MB */
u-boot,boot-led = "module_led";
};
chosen {
stdout-path = "serial0:115200n8";
u-boot,spl-boot-order = "same-as-spl", &emmc, &sdmmc;
};
};
&binman {
simple-bin {
blob {
offset = <((CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR - 64) * 512)>;
};
};
};
&emmc_clk {
u-boot,dm-pre-reloc;
};
&emmc_cmd {
u-boot,dm-pre-reloc;
};
&emmc_bus8 {
u-boot,dm-pre-reloc;
};
&gpio0 {
u-boot,dm-pre-reloc;
};
&gpio1 {
u-boot,dm-pre-reloc;
};
&gpio2 {
u-boot,dm-pre-reloc;
/*
* The Qseven BIOS_DISABLE signal on the PX30-µQ7 keeps the on-module
* eMMC powered-down initially (in fact it keeps the reset signal
* asserted). BIOS_DISABLE_OVERRIDE pin allows to re-enable eMMC after
* the SPL has been booted from SD Card.
*/
bios-disable-override-hog {
u-boot,dm-pre-reloc;
};
};
&pinctrl {
u-boot,dm-pre-reloc;
};
&pcfg_pull_none_8ma {
u-boot,dm-pre-reloc;
};
&pcfg_pull_up_8ma {
u-boot,dm-pre-reloc;
};
&sdmmc_bus4 {
u-boot,dm-pre-reloc;
};
&sdmmc_clk {
u-boot,dm-pre-reloc;
};
&sdmmc_cmd {
u-boot,dm-pre-reloc;
};
&sdmmc_det {
u-boot,dm-pre-reloc;
};
&uart0 {
clock-frequency = <24000000>;
u-boot,dm-pre-reloc;
};
|
