14.06: remove HTML control codes

Signed-off-by: Ryan Harkin <ryan.harkin@linaro.org>

1 files changed, 4 insertions, 4 deletions

diff --git a/android/images/armv8-android-juno-lsk/HOWTO_gettingstarted.txt b/android/images/armv8-android-juno-lsk/HOWTO_gettingstarted.txt
index 844917e..ebc0a93 100644
--- a/android/images/armv8-android-juno-lsk/HOWTO_gettingstarted.txt
+++ b/android/images/armv8-android-juno-lsk/HOWTO_gettingstarted.txt
@@ -157,11 +157,11 @@ The Mali GPU in Juno is able to use a variety of texture compression formats, ma
 
 3.      Connect the 12 volt power supply to the board.
 
-The serial terminal will show the command prompt Cmd>;
+The serial terminal will show the command prompt Cmd>
 
-4.      At the Cmd>; prompt on the serial terminal, issue the command usb_on
+4.      At the Cmd> prompt on the serial terminal, issue the command usb_on
 
-bc. Cmd>; usb_on
+bc. Cmd> usb_on
 
 The configuration flash memory should now be visible on the host computer as a mass storage device.
 
@@ -171,7 +171,7 @@ The configuration flash memory should now be visible on the host computer as a m
 
 7.      In the [SCC REGISTERS] section, below the “TOTALSCCS” line, insert the following line:
 
-SCC: 0x05C <value from step 6 above>;           ;Optional comment to explain which texture you have enabled
+SCC: 0x05C <value from step 6 above>           ;Optional comment to explain which texture you have enabled
 
 8.      Update the TOTALSCCS count (increment it by one) so that it now reflects the total number of SCC registers that are programmed.