=== D01Board OVERVIEW ===

The project aims to support UEFI for D01 Board using the edk2
code base.

=== STATUS ===

Current capabilities:
* Uefi Boot from NORFLASH

=== FUTURE PLANS ===

* Support for PXE, SATA, ACPI, USB
  - KeyBoard, Mouse and MassStorage

=== BUILDING D01 Board ===

Pre-requisites:
* Build environment capable of build the edk2 MdeModulePkg.
* A properly configured ASL compiler:
  - Intel ASL compiler: Available from http://www.acpica.org
  - Microsoft ASL compiler: Available from http://www.acpi.info

Build the D01BoardPkg by running from the Workspace
If you are using armcc as your compiler, you can build the project:
build -D BIOS_L1 -p HisiPkg/D01BoardPkg/D01BoardPkg.dsc -b DEBUG
If you are using gcc as your compiler, you can build the project:
 ./uefi-build.sh -b DEBUG d01

Following the edk2 build process, you will find the D01 binaries
under the $WORKSPACE/Build/*/*/FV directory. You can find the below
mentioned binary image.
D01.fd

=== RUNNING D01BoardPkg on the D01 board ===
* If you can enter into the shell, connet the network cable from the D01 device to the PC terminal
* Write BIOS to NORFLASH by using comands as follows:
D01 >ifconfig -s eth0 192.168.10.50 255.255.255.0 192.168.10.1
D01 >provision 192.168.10.100  -u admin -p admin -f norflash_header
D01 >writefiletonor 0 norflash_header
D01 >provision 192.168.10.100  -u admin -p admin -f D01.fd
D01 >updateL1 D01.fd
* If the NORFLASH in your board have nothing, you should adopt other method such as JTAG
* Now the booting device is ready to be used.
* Connect the Uart cable from the D01 device to the PC terminal.
* Power ON the Device.
* The boot message should be visible on the termial.
* Finally, it should give boot options.