metadata:
    name: android-bluetooth-pair
    format: "Manual Test Definition 1.0"
    description: "Test if Bluetooth pairing works well"
    maintainer:
        - amit.khare@linaro.org
    os:
        - android
    scope:
        - functional
    devices:
        - panda
        - panda-es
        - hi6220-hikey
    environment:
        - manual-test

run:
    steps:
        - After the board booted successfully, enable Bluetooth by click Settings -> Wireless and Networks -> Bluetooth.
        - After Bluetooth turned ON and surround devices (if any) showed up, turn Bluetooth OFF.
        - Perform above ON and OFF procedures again.
        - Make sure BT enabled device is in the radio range and in discovery mode
        - Pair the nearby device (enter PIN if needed)
    expected:
        - Bluetooth feature should can be continuously enabled and disabled at least twice without any error
        - Nearby devices should be shown in the discoveried device list on the board
        - Pairing should be done successfully