aboutsummaryrefslogtreecommitdiff
path: root/doc/README.mx28evk
blob: 76db474bfb63e3ee7c8c64e377f122d575a8e865 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
FREESCALE MX28EVK
==================

Supported hardware: only MX28EVK rev D is supported in U-boot.

Files of the MX28EVK port
--------------------------

arch/arm/cpu/arm926ejs/mxs/	- The CPU support code for the Freescale i.MX28
arch/arm/include/asm/arch-mxs/	- Header files for the Freescale i.MX28
board/freescale/mx28evk/	- MX28EVK board specific files
include/configs/mx28evk.h	- MX28EVK configuration file

Jumper configuration
---------------------

To boot MX28EVK from an SD card, set the boot mode DIP switches as:

   * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42)
   * JTAG PSWITCH RESET: To the right (reset disabled)
   * Battery Source: Down
   * Wall 5V: Up
   * VDD 5V: To the left (off)
   * Hold Button: Down (off)


Environment Storage
-------------------

There are two targets for mx28evk:

"make mx28evk_config"		- store enviroment variables into MMC

or

"make mx28evk_nand_config"	- store enviroment variables into NAND flash

Choose the target accordingly.

Note: The mx28evk board does not come with a NAND flash populated from the
factory. It comes with an empty slot (U23), which allows the insertion of a
48-pin TSOP flash device.

Follow the instructions from doc/README.mx28_common to generate a bootable SD
card.

Insert the SD card in slot 0, power up the board and U-boot will boot.