aboutsummaryrefslogtreecommitdiff
path: root/drivers/scsi
AgeCommit message (Expand)Author
2011-05-23Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jik...Linus Torvalds
2011-05-20Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6Linus Torvalds
2011-05-20Merge git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6Linus Torvalds
2011-05-18Merge branch 'devicetree/merge' of git://git.secretlab.ca/git/linux-2.6Linus Torvalds
2011-05-18drivercore: revert addition of of_match to struct deviceGrant Likely
2011-05-18Merge branch 'for-linus' of git://git.kernel.dk/linux-2.6-blockLinus Torvalds
2011-05-17scsi: remove performance regression due to async queue runJens Axboe
2011-05-17[SCSI] qla2xxx: Refactor call to qla2xxx_read_sfp for thermal temperature.Joe Carnuccio
2011-05-17[SCSI] qla2xxx: Unify the read/write sfp mailbox command routines.Joe Carnuccio
2011-05-17[SCSI] qla2xxx: Clear complete initialization control block.Andrew Vasquez
2011-05-17[SCSI] qla2xxx: Allow an override of the registered maximum LUN.Andrew Vasquez
2011-05-17[SCSI] qla2xxx: Add host number in reset and quiescent message logs.Saurav Kashyap
2011-05-17[SCSI] qla2xxx: Correctly read sfp single byte mailbox register.Joe Carnuccio
2011-05-17[SCSI] qla2xxx: Add qla82xx_rom_unlock() function.Chad Dupuis
2011-05-17[SCSI] qla2xxx: Log if qla82xx firmware fails to load from flash.Chad Dupuis
2011-05-17[SCSI] qla2xxx: Use passed in host to initialize local scsi_qla_host in queue...Madhuranath Iyengar
2011-05-17[SCSI] qla2xxx: Correct buffer start in edc sysfs debug print.Joe Carnuccio
2011-05-17[SCSI] qla2xxx: Update firmware version after flash update for ISP82xx.Saurav Kashyap
2011-05-17[SCSI] qla2xxx: Fix hang during driver unload when vport is active.Arun Easi
2011-05-17[SCSI] qla2xxx: Properly set the dsd_list_len for dsd_chaining in cmd type 6.Andrew Vasquez
2011-05-17[SCSI] qla2xxx: Fix virtual port failing to login after chip reset.Saurav Kashyap
2011-05-17[SCSI] qla2xxx: Fix vport delete hang when logins are outstanding.Arun Easi
2011-05-17[SCSI] hpsa: Change memset using sizeof(ptr) to sizeof(*ptr)Joe Perches
2011-05-17[SCSI] ipr: Rate limit DMA mapping errorsAnton Blanchard
2011-05-17[SCSI] hpsa: add P2000 to list of shared SAS devicesStephen M. Cameron
2011-05-17[SCSI] hpsa: do not attempt PCI power management reset method if we know it w...Stephen M. Cameron
2011-05-17[SCSI] hpsa: remove superfluous sleeps around reset codeStephen M. Cameron
2011-05-17[SCSI] hpsa: do soft reset if hard reset is brokenStephen M. Cameron
2011-05-17[SCSI] hpsa: use new doorbell-bit-5 reset methodStephen M. Cameron
2011-05-17[SCSI] hpsa: remove atrophied hpsa_scsi_setup functionStephen M. Cameron
2011-05-17[SCSI] hpsa: clarify messages around reset behaviorStephen M. Cameron
2011-05-17[SCSI] hpsa: increase time to wait for board resetStephen M. Cameron
2011-05-17[SCSI] hpsa: factor out irq request codeStephen M. Cameron
2011-05-17[SCSI] hpsa: factor out cmd pool allocation functionsStephen M. Cameron
2011-05-17[SCSI] hpsa: wait longer for no-op to complete after resetting controllerStephen M. Cameron
2011-05-17[SCSI] hpsa: do a better job of detecting controller reset failureStephen M. Cameron
2011-05-17[SCSI] hpsa: delete old unused padding garbageStephen M. Cameron
2011-05-17[SCSI] hpsa: remove unused parameter from hpsa_complete_scsi_command()Stephen M. Cameron
2011-05-17[SCSI] hpsa: add readl after writel in interrupt mask setting codeStephen M. Cameron
2011-05-17[SCSI] hpsa: do readl after writel in main i/o path to ensure commands don't ...Stephen M. Cameron
2011-05-10treewide: fix a few typos in commentsJustin P. Mattock
2011-05-03libcxgbi: Use flowi4's saddr in cxgbi_check_route().David S. Miller
2011-05-03ipv4: Make caller provide on-stack flow key to ip_route_output_ports().David S. Miller
2011-05-03[SCSI] fix oops in scsi_run_queue()James Bottomley
2011-05-01[SCSI] be2iscsi: update versionJayamohan Kallickal
2011-05-01[SCSI] be2iscsi: fix chip cleanupJayamohan Kallickal
2011-05-01[SCSI] be2iscsi: fix boot hang due to interrupts not getting rearmedJayamohan Kallickal
2011-05-01[SCSI] arcmsr: simplify assumptions in dma_alloc_coherent()Tomas Henzl
2011-05-01[SCSI] arcmsr: simplify some double loops in sleeping functionsTomas Henzl
2011-05-01[SCSI] bnx2fc: setup em for npiv portVasu Dev