aboutsummaryrefslogtreecommitdiff
path: root/Documentation/sound/alsa/ALSA-Configuration.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/sound/alsa/ALSA-Configuration.txt')
-rw-r--r--Documentation/sound/alsa/ALSA-Configuration.txt30
1 files changed, 30 insertions, 0 deletions
diff --git a/Documentation/sound/alsa/ALSA-Configuration.txt b/Documentation/sound/alsa/ALSA-Configuration.txt
index 4252697a95d..1c8eb4518ce 100644
--- a/Documentation/sound/alsa/ALSA-Configuration.txt
+++ b/Documentation/sound/alsa/ALSA-Configuration.txt
@@ -60,6 +60,12 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
slots - Reserve the slot index for the given driver.
This option takes multiple strings.
See "Module Autoloading Support" section for details.
+ debug - Specifies the debug message level
+ (0 = disable debug prints, 1 = normal debug messages,
+ 2 = verbose debug messages)
+ This option appears only when CONFIG_SND_DEBUG=y.
+ This option can be dynamically changed via sysfs
+ /sys/modules/snd/parameters/debug file.
Module snd-pcm-oss
------------------
@@ -513,6 +519,26 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
or input, but you may use this module for any application which
requires a sound card (like RealPlayer).
+ pcm_devs - Number of PCM devices assigned to each card
+ (default = 1, up to 4)
+ pcm_substreams - Number of PCM substreams assigned to each PCM
+ (default = 8, up to 16)
+ hrtimer - Use hrtimer (=1, default) or system timer (=0)
+ fake_buffer - Fake buffer allocations (default = 1)
+
+ When multiple PCM devices are created, snd-dummy gives different
+ behavior to each PCM device:
+ 0 = interleaved with mmap support
+ 1 = non-interleaved with mmap support
+ 2 = interleaved without mmap
+ 3 = non-interleaved without mmap
+
+ As default, snd-dummy drivers doesn't allocate the real buffers
+ but either ignores read/write or mmap a single dummy page to all
+ buffer pages, in order to save the resouces. If your apps need
+ the read/ written buffer data to be consistent, pass fake_buffer=0
+ option.
+
The power-management is supported.
Module snd-echo3g
@@ -768,6 +794,10 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
bdl_pos_adj - Specifies the DMA IRQ timing delay in samples.
Passing -1 will make the driver to choose the appropriate
value based on the controller chip.
+ patch - Specifies the early "patch" files to modify the HD-audio
+ setup before initializing the codecs. This option is
+ available only when CONFIG_SND_HDA_PATCH_LOADER=y is set.
+ See HD-Audio.txt for details.
[Single (global) options]
single_cmd - Use single immediate commands to communicate with