blob: 7d351968ef13a84a01e48730f1322398798ddcf0 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
|
Instructions for https://android-build.linaro.org/builds/~linaro-android/vexpress-jb-gcc47-armlt-tracking-open/
= Get artifacts =
Scroll down to the 'Downloads' section
Click on each link to download:
target/product/vexpress/boot.tar.bz2
target/product/vexpress/system.tar.bz2
target/product/vexpress/userdata.tar.bz2
= Get linaro image tools =
Run these commands to get all the dependencies for linaro-image-tools and the tip of linaro-image-tools
$ sudo add-apt-repository ppa:linaro-maintainers/tools
$ sudo apt-get update
$ sudo apt-get install linaro-image-tools
If you're using a released build (with a -release or from releases.linaro.org), skip this step.
If you're using a "tip" build do not skip the step and do the following:
$ sudo apt-get install bzr
$ bzr branch lp:linaro-image-tools
= Create media (SD card) =
Disable automount (instructions provided for Gnome)
$ TMP1=$(dconf read /org/gnome/desktop/media-handling/automount)
$ TMP2=$(dconf read /org/gnome/desktop/media-handling/automount-open)
$ dconf write /org/gnome/desktop/media-handling/automount false
$ dconf write /org/gnome/desktop/media-handling/automount-open false
Insert an SD card
Run 'dmesg'
$ dmesg
Look for a line that looks like the following at the end of the log
[288582.790722] sdc: sdc1 sdc2 sdc3 sdc4 < sdc5 sdc6 >
WARNING: In the next step, make sure you use /dev/"whatever you see above".
You can erase your hard drive with the wrong parameter.
Run linaro image tools
$ linaro-android-media-create --mmc /dev/sdc --dev vexpress --boot boot.tar.bz2 --system system.tar.bz2 --userdata userdata.tar.bz2
If you're using tip of linaro image tools
$ ./linaro-image-tools/linaro-android-media-create --mmc /dev/sdc --dev vexpress --boot boot.tar.bz2 --system system.tar.bz2 --userdata userdata.tar.bz2
Restore automount
$ dconf write /org/gnome/desktop/media-handling/automount $TMP1
$ dconf write /org/gnome/desktop/media-handling/automount-open $TMP2
Remove the SD card from the device writer and plug it into the board.
= Check console output =
Plug in an USB-to-serial converter and run minicom
$ minicom -D /dev/ttyUSB0 -b 38400 -w -C minicom.txt OR minicom -D /dev/ttyS0 -w -C minicom.txt
= Notes =
For new users, Versatile Express setup page is available at:
http://wiki.linaro.org/ARM/VersatileExpressSetup
|