diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mfd/axp20x.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/mfd/axp20x.txt | 11 |
1 files changed, 7 insertions, 4 deletions
diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt index 9455503b0299..188f0373d441 100644 --- a/Documentation/devicetree/bindings/mfd/axp20x.txt +++ b/Documentation/devicetree/bindings/mfd/axp20x.txt @@ -28,7 +28,6 @@ Required properties: * "x-powers,axp809" * "x-powers,axp813" - reg: The I2C slave address or RSB hardware address for the AXP chip -- interrupt-parent: The parent interrupt controller - interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin - interrupt-controller: The PMIC has its own internal IRQs - #interrupt-cells: Should be set to 1 @@ -43,10 +42,13 @@ Optional properties: regulator to drive the OTG VBus, rather then as an input pin which signals whether the board is driving OTG VBus or not. - (axp221 / axp223 / axp813 only) + (axp221 / axp223 / axp803/ axp813 only) -- x-powers,master-mode: Boolean (axp806 only). Set this when the PMIC is - wired for master mode. The default is slave mode. +- x-powers,self-working-mode and + x-powers,master-mode: Boolean (axp806 only). Set either of these when the + PMIC is wired for self-working mode or master mode. + If neither is set then slave mode is assumed. + This corresponds to how the MODESET pin is wired. - <input>-supply: a phandle to the regulator supply node. May be omitted if inputs are unregulated, such as using the IPSOUT output @@ -132,6 +134,7 @@ FLDO2 : LDO : fldoin-supply : shared supply LDO_IO0 : LDO : ips-supply : GPIO 0 LDO_IO1 : LDO : ips-supply : GPIO 1 RTC_LDO : LDO : ips-supply : always on +DRIVEVBUS : Enable output : drivevbus-supply : external regulator AXP806 regulators, type, and corresponding input supply names: |