Merge tag 'v3.14.42' of git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable into linux-linaro-lsk-v3.14lsk-v3.14-15.05

This is the 3.14.42 stable release

* tag 'v3.14.42' of git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable: (26 commits)
  Linux 3.14.42
  ARC: signal handling robustify
  UBI: fix soft lockup in ubi_check_volume()
  compal-laptop: Fix leaking hwmon device
  Drivers: hv: vmbus: Don't wait after requesting offers
  staging: panel: fix lcd type
  usb: gadget: printer: enqueue printer's response for setup request
  usb: host: ehci: use new USB_RESUME_TIMEOUT
  usb: host: oxu210hp: use new USB_RESUME_TIMEOUT
  usb: musb: use new USB_RESUME_TIMEOUT
  drm/radeon: add SI DPM quirk for Sapphire R9 270 Dual-X 2G GDDR5
  3w-sas: fix command completion race
  3w-9xxx: fix command completion race
  3w-xxxx: fix command completion race
  ext4: fix data corruption caused by unwritten and delayed extents
  rbd: end I/O the entire obj_request on error
  tty/serial: at91: maxburst was missing for dma transfers
  ASoC: dapm: Enable autodisable on SOC_DAPM_SINGLE_TLV_AUTODISABLE
  serial: of-serial: Remove device_type = "serial" registration
  ALSA: hda - Add mute-LED mode control to Thinkpad
  ...

6 files changed, 29 insertions, 14 deletions

diff --git a/drivers/usb/gadget/printer.c b/drivers/usb/gadget/printer.c
index 69b76efd11e9..44e698cd5246 100644
--- a/drivers/usb/gadget/printer.c
+++ b/drivers/usb/gadget/printer.c
@@ -975,6 +975,15 @@ unknown:
 		break;
 	}
 	/* host either stalls (value < 0) or reports success */
+	if (value >= 0) {
+		req->length = value;
+		req->zero = value < wLength;
+		value = usb_ep_queue(cdev->gadget->ep0, req, GFP_ATOMIC);
+		if (value < 0) {
+			ERROR(dev, "%s:%d Error!\n", __func__, __LINE__);
+			req->status = 0;
+		}
+	}
 	return value;
 }
 
diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c
index 992ca7d2f14d..1e0b9b97891e 100644
--- a/drivers/usb/host/ehci-hcd.c
+++ b/drivers/usb/host/ehci-hcd.c
@@ -792,12 +792,12 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd)
 					ehci->reset_done[i] == 0))
 				continue;
 
-			/* start 20 msec resume signaling from this port,
-			 * and make khubd collect PORT_STAT_C_SUSPEND to
-			 * stop that signaling.  Use 5 ms extra for safety,
-			 * like usb_port_resume() does.
+			/* start USB_RESUME_TIMEOUT msec resume signaling from
+			 * this port, and make hub_wq collect
+			 * PORT_STAT_C_SUSPEND to stop that signaling.
 			 */
-			ehci->reset_done[i] = jiffies + msecs_to_jiffies(25);
+			ehci->reset_done[i] = jiffies +
+				msecs_to_jiffies(USB_RESUME_TIMEOUT);
 			set_bit(i, &ehci->resuming_ports);
 			ehci_dbg (ehci, "port %d remote wakeup\n", i + 1);
 			usb_hcd_start_port_resume(&hcd->self, i);
diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c
index 7d6f64c447bf..323c5faf7a2f 100644
--- a/drivers/usb/host/ehci-hub.c
+++ b/drivers/usb/host/ehci-hub.c
@@ -482,10 +482,13 @@ static int ehci_bus_resume (struct usb_hcd *hcd)
 		ehci_writel(ehci, temp, &ehci->regs->port_status [i]);
 	}
 
-	/* msleep for 20ms only if code is trying to resume port */
+	/*
+	 * msleep for USB_RESUME_TIMEOUT ms only if code is trying to resume
+	 * port
+	 */
 	if (resume_needed) {
 		spin_unlock_irq(&ehci->lock);
-		msleep(20);
+		msleep(USB_RESUME_TIMEOUT);
 		spin_lock_irq(&ehci->lock);
 		if (ehci->shutdown)
 			goto shutdown;
@@ -953,7 +956,7 @@ static int ehci_hub_control (
 			temp &= ~PORT_WAKE_BITS;
 			ehci_writel(ehci, temp | PORT_RESUME, status_reg);
 			ehci->reset_done[wIndex] = jiffies
-					+ msecs_to_jiffies(20);
+					+ msecs_to_jiffies(USB_RESUME_TIMEOUT);
 			set_bit(wIndex, &ehci->resuming_ports);
 			usb_hcd_start_port_resume(&hcd->self, wIndex);
 			break;
diff --git a/drivers/usb/host/oxu210hp-hcd.c b/drivers/usb/host/oxu210hp-hcd.c
index e07248b6ab67..1b1e6e0d9270 100644
--- a/drivers/usb/host/oxu210hp-hcd.c
+++ b/drivers/usb/host/oxu210hp-hcd.c
@@ -2500,11 +2500,12 @@ static irqreturn_t oxu210_hcd_irq(struct usb_hcd *hcd)
 					|| oxu->reset_done[i] != 0)
 				continue;
 
-			/* start 20 msec resume signaling from this port,
-			 * and make khubd collect PORT_STAT_C_SUSPEND to
+			/* start USB_RESUME_TIMEOUT resume signaling from this
+			 * port, and make hub_wq collect PORT_STAT_C_SUSPEND to
 			 * stop that signaling.
 			 */
-			oxu->reset_done[i] = jiffies + msecs_to_jiffies(20);
+			oxu->reset_done[i] = jiffies +
+				msecs_to_jiffies(USB_RESUME_TIMEOUT);
 			oxu_dbg(oxu, "port %d remote wakeup\n", i + 1);
 			mod_timer(&hcd->rh_timer, oxu->reset_done[i]);
 		}
diff --git a/drivers/usb/musb/musb_core.c b/drivers/usb/musb/musb_core.c
index 07576907e2c6..ec69b90475c7 100644
--- a/drivers/usb/musb/musb_core.c
+++ b/drivers/usb/musb/musb_core.c
@@ -99,6 +99,7 @@
 #include <linux/platform_device.h>
 #include <linux/io.h>
 #include <linux/dma-mapping.h>
+#include <linux/usb.h>
 
 #include "musb_core.h"
 
@@ -477,10 +478,11 @@ static irqreturn_t musb_stage0_irq(struct musb *musb, u8 int_usb,
 						(USB_PORT_STAT_C_SUSPEND << 16)
 						| MUSB_PORT_STAT_RESUME;
 				musb->rh_timer = jiffies
-						 + msecs_to_jiffies(20);
+					+ msecs_to_jiffies(USB_RESUME_TIMEOUT);
+
 				schedule_delayed_work(
 					&musb->finish_resume_work,
-					msecs_to_jiffies(20));
+					msecs_to_jiffies(USB_RESUME_TIMEOUT));
 
 				musb->xceiv->state = OTG_STATE_A_HOST;
 				musb->is_active = 1;
diff --git a/drivers/usb/musb/musb_virthub.c b/drivers/usb/musb/musb_virthub.c
index e2d2d8c9891b..0241a3a0d63e 100644
--- a/drivers/usb/musb/musb_virthub.c
+++ b/drivers/usb/musb/musb_virthub.c
@@ -136,7 +136,7 @@ void musb_port_suspend(struct musb *musb, bool do_suspend)
 		/* later, GetPortStatus will stop RESUME signaling */
 		musb->port1_status |= MUSB_PORT_STAT_RESUME;
 		schedule_delayed_work(&musb->finish_resume_work,
-				      msecs_to_jiffies(20));
+				      msecs_to_jiffies(USB_RESUME_TIMEOUT));
 	}
 }