From 55556da01284af8c2174b786b3eca8e11301b656 Mon Sep 17 00:00:00 2001 From: Philip Langdale Date: Fri, 16 Mar 2007 19:39:00 -0700 Subject: MMC: Fix handling of low-voltage cards Fix handling of low voltage MMC cards. The latest MMC and SD specs both agree that support for low-voltage operations is indicated by bit 7 in the OCR. The MMC spec states that the low voltage range is 1.65-1.95V while the SD spec leaves the actual voltage range undefined - meaning that there is still no such thing as a low voltage SD card. However, an old Sandisk spec implied that bits 7.0 represented voltages below 2.0V in 1V or 0.5V increments, and the code was accordingly written with that expectation. This confusion meant that host drivers attempting to support the typical low voltage (1.8V) would set the wrong bits in the host OCR mask (usually bits 5 and/or 6) resulting in the the low voltage mode never being used. This change corrects the low voltage range and adds sanity checks on the reserved bits (0-6) and for SD cards that claim to support low-voltage operations. Signed-off-by: Philip Langdale Signed-off-by: Pierre Ossman --- drivers/mmc/host/sdhci.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) (limited to 'drivers/mmc/host') diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index a57f6a3d48d..ff5bf73cdd2 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -659,8 +659,7 @@ static void sdhci_set_power(struct sdhci_host *host, unsigned short power) pwr = SDHCI_POWER_ON; switch (1 << power) { - case MMC_VDD_17_18: - case MMC_VDD_18_19: + case MMC_VDD_165_195: pwr |= SDHCI_POWER_180; break; case MMC_VDD_29_30: @@ -1280,7 +1279,7 @@ static int __devinit sdhci_probe_slot(struct pci_dev *pdev, int slot) if (caps & SDHCI_CAN_VDD_300) mmc->ocr_avail |= MMC_VDD_29_30|MMC_VDD_30_31; if (caps & SDHCI_CAN_VDD_180) - mmc->ocr_avail |= MMC_VDD_17_18|MMC_VDD_18_19; + mmc->ocr_avail |= MMC_VDD_165_195; if (mmc->ocr_avail == 0) { printk(KERN_ERR "%s: Hardware doesn't report any " -- cgit v1.2.3