Age | Commit message (Expand) | Author |
2012-08-05 | da850/omap-l138: add support for direct NOR boot mode | Lad, Prabhakar |
2012-08-05 | da850/omap-l138: Add support for NAND SPL | Lad, Prabhakar |
2012-08-05 | da850/omap-l138: Fix NAND flash timings | Lad, Prabhakar |
2012-08-05 | da850/omap-l138: Add support to read u-boot image from MMC/SD | Lad, Prabhakar |
2012-08-05 | da850/omap-l138: Define SPI specific configs for SPL only when SPI is used | Lad, Prabhakar |
2012-08-05 | arm, davinci: perform check for initializing global data and serial init | Lad, Prabhakar |
2012-08-05 | da850/omap-l138: Make MMC and NOR support mutually exclusive | Rajashekhara, Sudhakar |
2012-08-05 | da850/omap-l138: modifications for Logic PD Rev.3 AM18xx EVM | Rajashekhara, Sudhakar |
2012-08-05 | da850/omap-l138: Add MMC support for DA850/OMAP-L138 | Lad, Prabhakar |
2012-08-05 | omap: am33xx: enable gpio support | Steve Sakoman |
2012-08-05 | omap: am335x_evm: remove unused definitions | Steve Sakoman |
2012-08-05 | OMAP3: mcx: read hot-water-button after reset | Stefano Babic |
2012-08-05 | OMAP3: mcx: updated default environment | Stefano Babic |
2012-08-05 | OMAP3: mcx: set pinmux for uart4 | Stefano Babic |
2012-08-05 | mcx: increased buffer for command line | Stefano Babic |
2012-08-05 | arm: omap3: cm-t35: minor comment and printf change | Igor Grinberg |
2012-08-05 | hawkboard/omapl-138: Add support for generating ais image for hawkboard | Sughosh Ganu |
2012-08-05 | omap24xx_i2c: add 2-byte address support | Ilya Yanok |
2012-07-31 | powerpc/82xx: adapt SDRAM settings for mgcoge3ne | Gerlando Falauto |
2012-07-31 | powerpc/82xx: use SDRAM detection for mgcoge2ne | Gerlando Falauto |
2012-07-31 | powerpc/82xx: add SDRAM detection for km82xx | Gerlando Falauto |
2012-07-31 | powerpc/82xx: move km/km82xx-common.h within km82xx.h | Gerlando Falauto |
2012-07-31 | powerpc/82xx: merge mgcoge.h and mgcoge3ne.h into km82xx.h | Gerlando Falauto |
2012-07-31 | powerpc/82xx: move mgcoge, mgcoge3ne defines to ease subsequent merge | Gerlando Falauto |
2012-07-31 | powerpc/82xx: remove unused define for mgcoge3ne | Holger Brunck |
2012-07-31 | SMDK6400: Add MAINTAINERS entry | Zhong Hongbo |
2012-07-31 | Merge branch 'master' of git://git.denx.de/u-boot-i2c | Wolfgang Denk |
2012-07-31 | Merge branch 'master' of git://git.denx.de/u-boot-microblaze | Wolfgang Denk |
2012-07-31 | km/common: remove printfs for i2c deblocking code | Holger Brunck |
2012-07-31 | CONFIG: SMDK5250: I2C: Enable I2C | Rajeshwari Shinde |
2012-07-31 | I2C: Add support for Multi channel | Rajeshwari Shinde |
2012-07-31 | I2C: Modify the I2C driver for EXYNOS5 | Rajeshwari Shinde |
2012-07-31 | I2C: Move struct s3c24x0_i2c to a common place. | Rajeshwari Shinde |
2012-07-31 | EXYNOS: PINMUX: Add pinmux support for I2C | Rajeshwari Shinde |
2012-07-31 | EXYNOS5: define EXYNOS5_I2C_SPACING | Rajeshwari Shinde |
2012-07-31 | EXYNOS: Add I2C base address. | Rajeshwari Shinde |
2012-07-31 | EXYNOS: CLK: Add i2c clock | Rajeshwari Shinde |
2012-07-31 | mx6qsabrelite: add i2c multi-bus support | Troy Kisky |
2012-07-31 | imx-common: add i2c.c for bus recovery support | Troy Kisky |
2012-07-31 | i.mx53: add definition for I2C3_BASE_ADDR | Troy Kisky |
2012-07-31 | i.mx: iomux-v3.c: move to imx-common directory | Troy Kisky |
2012-07-31 | i.mx: iomux-v3.h: move to imx-common include directory | Troy Kisky |
2012-07-31 | iomux-v3: remove include of mx6x_pins.h | Troy Kisky |
2012-07-31 | mxc_i2c: finish adding CONFIG_I2C_MULTI_BUS support | Troy Kisky |
2012-07-31 | mxc_i2c: add bus recovery support | Troy Kisky |
2012-07-31 | mxc_i2c: prep work for multiple busses support | Troy Kisky |
2012-07-31 | mxc_i2c: add i2c_regs argument to i2c_imx_stop | Troy Kisky |
2012-07-31 | mxc_i2c: add retries | Troy Kisky |
2012-07-31 | mxc_i2c: check for arbitration lost | Troy Kisky |
2012-07-31 | mxc_i2c: change slave addr if conflicts with destination. | Troy Kisky |