| Age | Commit message (Collapse) | Author |
|---|
|
From the ARM SCP Firmware release:
ramfw.bin => SOFTWARE/scp_bl2.bin
romfw_bypass.bin => SOFTWARE/scp_bl1.bin
Release note from ARM below.
SCP firmware:
-------------
Tag: v1.25.0-rc2
Changes from v1.21.0-rc0 to v1.25.0-rc2
Changes for Juno since v1.21.0:
- Added SCMIv1 support
- Added Shared Data Storage (SDS) to exchange information with TF during the boot sequence
- Added new boot loader over SDS
- Fix: Bumped DVFS latency information to match hardware (1.5ms)
- Fix: Enable CoreSight timestamp generator (with halt-on-debug support) on debug power domain power up
- Removed implicit GPU power up
Signed-off-by: Ryan Harkin <ryan.harkin@linaro.org>
|
|
From the ARM SCP Firmware release:
ramfw.bin => SOFTWARE/scp_bl2.bin
romfw_bypass.bin => SOFTWARE/scp_bl1.bin
Release note from ARM below.
SCP firmware:
-------------
Tag: v1.21.0-rc1
Changes from v1.20.0-rc0 to v1.21.0-rc1
Changes for Juno since v1.20.0:
- Juno: Add GPU power supply management
- Juno: Add core warm reset support in ROM (enabling AARCH32 support)
- drivers/xrp7724: Increase delay period when enabling channel
- drivers/xrp7724: Fix setting voltage on disabled outputs
==================================================================================================
SCP firmware:
-------------
Tag: v1.20.0-rc0 / NOT RELEASED TO LINARO
This tag was never release to Linaro as there were no Juno specific
changes.
==================================================================================================
SCP firmware:
-------------
Tag: v1.19.0-rc0 / NOT RELEASED TO LINARO
This tag was never release to Linaro as there were no Juno specific
changes.
==================================================================================================
Signed-off-by: Ryan Harkin <ryan.harkin@linaro.org>
|
|
BL0 has been renamed to SCP_BL1.
Bl30 has been renamed to SCP_Bl2.
Signed-off-by: Ryan Harkin <ryan.harkin@linaro.org>
|
